Getting Started with your 3Doodler Candy
Not sure where to begin with your 3Doodler Candy? You’re in the right place. The 3Doodler Candy is the first 3D pen made for kids and families to craft yummy candy creations, designed for ages 8+. Let’s jump into the essentials so you can start creating sweet works of art!
Basics
- Remember to always prepare parchment/baking paper and the candy pieces you want to join before powering on your 3Doodler Candy.
- Power on, insert Candy Capsules, and wait for the green light.
- Press and hold the Forward Button to extrude candy.
- Work quickly — the candy sets in about two to three seconds.
- If a joint hardens, reapply candy and try again.
- Use sturdy snacks like cookies, crackers, or pretzels for best results.
- Remember to always let the nozzle and candy cool before touching.
The Pen
Buttons & Parts
- Power Switch: Slide to turn the pen on/off.
- Forward Button: Press and hold to extrude candy.
- Pull Ring: Pull/slide to load and advance feed.
- Hatch: Removable cover for capsules and nozzle.
- Candy Capsules: Isomalt pellets inserted to extrude.
- Nozzle: Removable tip where candy is extruded.
- Pushrod: Rod that pushes capsules forward.
- USB-C Port: Connect cable to charge the battery.
Indicator Lights
- Solid Red: Pen is warming up.
- Solid Green: Fully heated and ready to use.
- Slowly Flashing Orange: Battery level is low.
- Quickly Flashing Orange: Pen is actively charging.
- Solid Orange: Charging complete; battery full.
Operation
Turn It On
Slide the power switch from OFF to ON. The LED turns Solid Red while heating. Wait for Solid Green.
Remove the Hatch
Pull back the Pull Ring. Squeeze the hatch sides and pull to release.
Add Candy Capsules
Install up to two candy capsules and reinstall the hatch.
Return the Pull Ring
Hold the Pull Ring while pressing the button. Gently push until resistance is felt, then begin extrusion.
Tips
Sticking Candy
Press the pen tip into the surface while extruding to help candy stick.
Smooth Doodling
Apply gentle pressure to the end of the pen for smooth extrusion.
Single Use Capsules
Doodled candy cannot be reused.
Shape Your Candy
Wait a few seconds after extrusion, then mold before it hardens.
Troubleshooting
Remove the Nozzle
- Turn on the pen and allow it to cool.
- Pull back the Pull Ring and remove the hatch.
- Use the included wrench tool to gently push the nozzle tip into the pen. The removed nozzle will be accessible in the hatch cutout.
Clean the Nozzle
- Soak the nozzle only (not the pen) in hot water for 2–3 hours for best results.
- Rinse the hatch with hot water.
- Use the included brush to loosen and remove any residual candy.
- Rinse and dry the nozzle. Do not submerge the pen.
Reinstall Nozzle
- Ensure the device is turned off.
- Use one hand to raise the heater door for access, and with the other hand, insert the nozzle.
Clean Pushrod
- Pull back the Pull Ring and remove the hatch.
- Use the wrench tool to loosen the pushrod.
- Slide the pushrod into the hatch opening.
- Carefully wipe the tip clean with a damp paper towel.
