Getting Started with your 3Doodler PRO
Not sure where to begin with your 3Doodler PRO? You’re in the right place. This pen’s ergonomic design and precise controls let you work with advanced materials — like wood, metal, and carbon fiber — right out of the box. Let’s jump into the essentials so you can start creating high-quality 3D models today.
Basics
Set the Temperature
- Plug in your 3Doodler PRO and turn it on.
- Use the Navigation Buttons to scroll through preset temperature modes displayed on the OLED screen.
- Press the Menu/Enter Button to select your desired material setting.
Set the Speed
- Adjust the extrusion speed (1–10) using the Navigation Buttons.
- Press the Menu/Enter Button to confirm your selection.
Wait for the Indicator Light
- The Indicator Light will turn:
- Blue when the pen reaches the preset temperature.
- Green when the pen reaches the custom temperature.
Insert the Filament
- Once the Indicator Light is Blue or Green, gently insert the filament into the Feed Port.
- The Drive Gear will automatically pull the filament through.
Start Doodling
- Press the Feed Button to begin extrusion.
- Anchor your filament to a surface or draw directly in the air.
- Press the Feed Button again to pause or stop extrusion.
The Pen
Buttons
- Feed Button: Starts and stops filament extrusion.
- Reverse Button: Retracts or unloads filament.
- Navigation Buttons: Adjust settings and scroll through menus.
- Menu/Enter Button: Selects and confirms settings.
- On/Off Switch: Powers the pen on and off.
Indicator Lights
- Red: Heating or waiting for a selection.
- Blue: Ready with preset temperature settings.
- Green: Ready in custom mode.
- Flashing Blue/Green: Reverse mode for preset or custom settings.
Operation
Feeding Strands
Insert the filament into the Feed Port until the Drive Gear engages and pulls it through automatically.
Pressing On Surface
To anchor your filament, press the nozzle firmly onto your surface for a few seconds before lifting.
Welding Filament
To connect two pieces of filament, touch the tip of the 3Doodler PRO to both pieces while extruding.
Finishing and Tips
Reverse and Remove Filament
- Ensure the pen is turned on and heated to the appropriate temperature.
- Press the Reverse Button to retract the filament.
- Once retracted, gently pull the filament out from the back of the pen.
- Always trim the melted end before reinserting to prevent clogs.
Snip Those Ends
After removing a filament strand, use scissors to cut and remove the melted end before reinserting it into the pen.
Troubleshooting
Jammed Filament
- Set the temperature to match the filament being used.
- Remove the nozzle using the Nozzle Tool (ensure the pen is heated).
- Use the Unblocking Tool to clear any jams from the nozzle end.
Short Filament Strands
Remove the maintenance cover to access the drive mechanism for easier removal of short strands.
Accessories
Swapping Nozzles
- Use the Nozzle Tool to change nozzles safely while the pen is heated.
- Ensure the pen is turned on and heated before removing or attaching nozzles.
Using the Mini DoodlePad
The Mini DoodlePad provides a grid-lined, transparent surface for precise and professional creations.
